Hitachi Zaxis 200LC Operator's Manual page 42

Monitor Panel Functions
1. Engine Coolant Temperature Gauge:
IMPORTANT: If needle points to "RED" zone, idle
engine to bring back needle to
"GREEN" zone before stopping
engine. If needle continues to rise,
shut engine OFF.
2. Fuel Gauge: Fuel machine before needle reaches
"E".
3. Display Select Switch: Press switch to display
Hour Meter, Trip Meter 1 or Trip Meter 2 information in
that order on the monitor display.
4. Set Switch: Press switch to change settings in Trip
Meter 1 or Trip Meter 2.
5. Work Mode Switch: Press switch to select Dig
Mode.
6. Fuel Level Indicator: Indicator will light when
approximately 80 liters (21 gal) of fuel remain.
7. Air Filter Restriction Indicator: Indicator will light
when the air filter elements are clogged.
8. Alternator Voltage Indicator: Indicator will light
with no or low alternator output.
9. Not Used:
10. Not Used:
11. Engine Coolant Level Indicator—If Equipped:
Indicator will light if engine coolant level is low.
12. Engine Oil Level Indicator—If Equipped:
Indicator will light if engine oil level is low.
13. Engine Oil Pressure Indicator:
IMPORTANT: If engine oil pressure light comes on
while operating, stop engine
immediately.
Operation—Operator's Station
Indicator will light and buzzer will sound when engine
oil pressure is low. Stop engine immediately.
NOTE: Cold oil, low oil level, or extreme off level
14. Pre-Heat Indicator: Orange indicator will light
when the key switch is turned to ON position in cold
weather. Light will turn off after a few seconds,
indicating that the preheat is complete.
15. Engine Coolant Temperature Indicator:
IMPORTANT: DO NOT stop engine when coolant
Indicator will light and buzzer will sound when engine
coolant overheats. Reduce load immediately and run
engine at slow idle. Inspect for debris around radiator.
Check coolant level in the radiator recovery tank.
16. Dig Mode Indicator: Indicator will light when Dig
Mode is selected.
17. Attachment Mode Indicator: Not used.
18. Monitor Display: Displays Hour Meter, Trip Meter
1 and Trip Meter 2 information.
19. Auto-Idle Indicator: Indicator will light when the
auto-idle/auto-acceleration switch is turned to the A/I or
the A/A position. Indicator will flash when engine is
started and either auto-idle or auto-acceleration mode
is already activated.
20. Auto-Acceleration Indicator: Indicator will light
when the auto-idle/auto-acceleration switch is turned to
the A/A position. Indicator will flash when engine is
started and auto-acceleration mode is already
activated.
2-1-4
operation may cause indicator to light.
temperature light comes on or
temperature will rise further. Reduce
load and run engine at slow idle. If
temperature light continues to stay
ON, shut engine OFF.
OUT1739,00001D8 –19–09JAN03–1/1
081407
PN=38