Hitachi Zaxis 200LC Operator's Manual page 157

10. Install suction screen with cover. Suction screen must
seal against outlet pipe in bottom of tank. If
necessary, loosen nut (2) to adjust rod length.
11. Install tank drain plug and bottom guard.
12. Add oil until it is between marks on sight glass. (See
Section 3-1.)
Suction Screen Rod (1)—Length
Suction Screen Rod Nut—Torque
Hydraulic Cover Cap Screw—
Torque .............................................................................
IMPORTANT: If the hydraulic pump is not filled with
oil, it will be damaged when the engine
is started.
13. Remove air bleed plugs (1) from hydraulic pump until
oil flows from bleed holes.
14. Install air bleed plugs in hydraulic pump.
15. Check oil level in sight glass. Add oil, if necessary.
16. Install tank cover and cap.
17. Connect pressure vent line to cover fitting.
18. Purge air from cylinders and swing motor by cycling
hydraulic functions.
Maintenance—Every 4000 Hours
Specification
.................................. 746 mm (29.4 in.)
........ 14.7—19.6 N•m (10.8—14.5 lb-ft)
49 N•m (36 lb-ft)
1—Suction Screen Rod
2—Suction Screen Rod Nut
1—Bleed Plug
3-12-3
TX14740,0001F41 –19–16JUN06–4/5
TX14740,0001F41 –19–16JUN06–5/5
081407
PN=153