Usb Interface; On/Off Button - Kerlink Wirnet iBTS Installation And Maintenance Manual

Note 1: COM port number must be adjusted depending on which serial port is used on the
computer.
Note 2: It is also possible to access to the debug interface by Ethernet connection by
connecting directly to the POE injector or the Ethernet switch (depending on the installation
topology).
Note 3: request default login/password to KERLINK.
Firmware upgrade can be performed with a USB key via the USB type A connector. The
connector is located on the CPU module as described below:
USB type A
connector
An ON/OFF button is located on the front side of the CPU module:
ON/OFF
button
This button is intended to perform a hard reboot, soft halt, power down (hard halt)and
power on of the Wirnet iBTS:
Classification
Internal Use
Confidential
Strict confidential
Figure 164 : USB connector of the Wirnet iBTS
Figure 165 : ON/OFF button of the Wirnet iBTS
This document is the strict property of Kerlink and shall not be either copied nor sent without express
Kerlink – 1 rue Jacqueline Auriol – 35235 THORIGNÉ-FOUILLARD
Wirnet iBTS

5.3.2 USB interface

5.3.3 ON/OFF button

written authorization of Kerlink
Kerlink m2m technologies reserved rights
Document title : Installation and
Maintenance Manual
Version : 2.0
Author : SNI
Date : 04/12/2018
Page 214 / 221