Kerlink Wirnet iBTS Installation And Maintenance Manual page 202

On the other side of the Ethernet cable, the RJ45 connector must be inserted into the RJ45
"Data + Power" port of the POE injector. This POE injector is connected to 230VAC mains
supply as detailed in §4.3.2.
« Data + Power »
port
RJ45 cable
Note 4: the PoE injector must be connected to the mains supply through a main electrical
board with surge protections type 1 and a secondary electrical board with surge protections
type 2 as detailed in §4.3.2.
Note 5: the PoE injectors detailed in §1.6.1.1 and §1.6.1.3 are intended for indoor
applications only.
Note 6: If the electrical installation does not include surge protections type 1 and 2, then an
outdoor PoE injector featuring better surge protection is required. These outdoor PoE
injector are detailed in §1.6.1.6 and § 1.6.1.7.
The AC/DC PoE injectors detailed in §1.6.1, are provided with E/F type cable (Europe) or B
type cable (USA).
Insert the plugs to the mains receptacle of the electrical installation.
Note: the E/F type or B type plugs must be inserted into the mains receptacle only once all
other connections are settled and USIM card inserted (see §4.7).
The Wirnet iBTS can be also supplied with an auxiliary DC power supply as a solar panel for
instance. The input voltage range is 11 to 56VDC. A 24V DC solar system is then
recommended for optimized performance.
A two-wire cable is required to interconnect the auxiliary power supply connector.
Classification
Internal Use
Confidential
Strict confidential
Figure 157 : Ethernet connection on PoE injector side
This document is the strict property of Kerlink and shall not be either copied nor sent without express
Kerlink – 1 rue Jacqueline Auriol – 35235 THORIGNÉ-FOUILLARD
Wirnet iBTS
4.6.4 Mains supply
4.6.5 Auxiliary power supply
written authorization of Kerlink
Kerlink m2m technologies reserved rights
Document title : Installation and
Maintenance Manual
Version : 2.0
Author : SNI
Date : 04/12/2018
Page 202 / 221