Configuring Network Parameters - Kerlink Wirnet iBTS Installation And Maintenance Manual

Several interfaces are available for debug and maintenance purpose. They are detailed in
§5.3. Their use is detailed in the following sections.
4.8.4.1 Configuration through the web interface
The iBTS can be graphically configured through a web interface, in addition to the command-
line interface which is used through the serial port or SSH connection.
To access the web interface, you must have a computer connected either through the local
interface port directly, or to the same network as the Ethernet PoE connection. Please
consult the Kerlink Wiki or contact KERLINK for more information and to get the credentials.
You will be greeted with the following login screen:

4.8.4.2 Configuring network parameters

The network bearer can be chosen among Ethernet, LTE and WLAN, according to the
available WAN modules plugged inside the gateway. The configuration parameters are:
 Ethernet :
o IPv4 mode : Automatic (DHCP) or Manual (static) or Off (disabled)
o IPv4 address (if static mode)
o IPv4 Gateway address & network mask
o IPv4 DNS resolver
 GSM / HSPA / LTE:
Classification
Internal Use
Confidential
Strict confidential
This document is the strict property of Kerlink and shall not be either copied nor sent without express
Kerlink – 1 rue Jacqueline Auriol – 35235 THORIGNÉ-FOUILLARD
Wirnet iBTS
4.8.4 Configuration
written authorization of Kerlink
Kerlink m2m technologies reserved rights
Document title : Installation and
Maintenance Manual
Version : 2.0
Author : SNI
Date : 04/12/2018
Page 209 / 221