Kerlink Wirnet iBTS Installation And Maintenance Manual page 207

Note 1: the outdoor PoE injector and Ethernet surge protectors have cable glands to insure
the ingress protection. RJ45 connectors must be inserted into the POE injector through the
cable glands.
Note 2: in both use cases, the earthing cables for the PoE injector, Ethernet surge
protection, RF coaxial surge protection and Wirnet iBTS mounting kit are not provided by
KERLINK.
4.8 Commissioning
The USIM card is mandatory to establish the LTE/3G/GPRS communications.
The USIM card to be used with the Wirnet iBTS must be a 2FF format.
KERLINK recommends the usage of a M2M UICC compliant with 3GPP TS 102.671. It offers
then a better temperature operating range, improved data retention and increased number
of UPDATE commands.
Before inserting the USIM card, pay attention that the Wirnet iBTS is unpowered by checking
that all LEDs of the CPU module are OFF.
USIM card insertion is based on a push-push mechanism.
Then, to insert a USIM card in the WAN module, follow the procedure:
 Open the enclosure (see §4.1)
 Insert carefully the USIM card in the WAN module respecting the USIM
orientation drawn besides the connector and as shown below
 Push the USIM card and released pressure until a "click" can be heard.
Classification
Internal Use
Confidential
Strict confidential
Figure 161 : USIM Card
This document is the strict property of Kerlink and shall not be either copied nor sent without express
Kerlink – 1 rue Jacqueline Auriol – 35235 THORIGNÉ-FOUILLARD
Wirnet iBTS
4.8.1 USIM card
written authorization of Kerlink
Kerlink m2m technologies reserved rights
Document title : Installation and
Maintenance Manual
Version : 2.0
Author : SNI
Date : 04/12/2018
Insert and press
the USIM card
here
Page 207 / 221