Table of Contents
Advertisement
Understanding the LCD Display Panel:
NOTE: The LCD displays menu options, operating instructions, and also information on what the
duplicator is doing. Use it to walk you through simple DVD duplicating.
You can select the following modes by pushing the SET button on the controller. Then push the
RUN button to perform that function.
Loading the Source DVD or CD
The Kanguru DVD Autoloader 200 uses an internal 80GB hard drive to store images of your
source or master discs. When the duplication process begins the system will read from the data
from this hard drive and burn it onto the target discs. To get your source material onto the
internal hard drive it must be loaded from one of the DVD/RW drives. To do so, simply insert your
master disc into any of the 3 drives and go to the LOAD function. Press the RUN button and the
data will be loaded onto the hard drive. This will be discussed in greater detail later on in this
manual in the Internal Hard Drive Management section.
Loading blank DVDs or CDs
There are three Disc Tubs included with your Autoloader 200 (see the Top View diagram above).
Each can hold up to 100 discs for duplication. By default the Autoloader will begin picking blank
discs from Disc Tub #2. If there aren't any discs in Disc Tub #2, the Autoloader will move to pick
from Disc Tub #1. Never load blank discs in Disc Tub#3, as that is only used as a finished tub. If
you plan to run a full 200 disc duplication then load 100 discs into Tub #2 and 100 disc into Tub
#1.
Advertisement
Table of Contents
