Rear View; Control Panel - Kanguru DVD Autoloader 200 User Manual

Rear View:

Control Panel:

Overview:
When you turn on your KanguruDVD-Autoloader 200, it will go through an initialization process to
setup the robotic arm, detect the DVD/RW drives, and read the internal hard drive. The detection
process will be displayed on the LCD screen.
After successful start-up, you will enter Operation Mode. In Operation Mode, you can use the
SET button to switch between modes, or you can press down the SET button continuously for 3
seconds to enter Setup Mode. Pressing the RUN button will perform a specified operation. When
you are ready to return from Setup Mode to Operation Mode, press the SET button continuously
for 3 seconds to return back to Operation Mode.
There are two buttons on the KanguruDVD-Duplicator console, the SET and RUN button. The
SET button is normally used when you need to switch between different modes and functions;
where the RUN button is used to change, select, or start a specific task. For further information,
please see Individual Settings.