Kanguru DVD Autoloader 200 User Manual page 13

3. "RAW" Raw writing method, when the "DAO" and "TAO" can not succeed in backing up your
disc, you may try this writing method.
*Default Setting is "DAO"
• DVD WRITING METHOD
Your KanguruDVD-Duplicator provides 2 different types of reading and writing modes for DVDs:
1. "DAO" Disc at Once, most Frequent writing.
2. "INC" Can be used to improve the compatibility of the final discs.
*Default Setting is "DAO"
• CD READING SPEED
Set the reading speed of the source drive.
Usable speed can be: "MX", "01", "02", "03", "04", "06", "08", "10",
"12", "16", "20", "24", "32", "40" "46", "48", and "52".
"MX" indicates the maximum speed. If you set this value to a value higher than the maximum
speed of your writer, your writer will operate at its maximum speed.
"MD" the reader uses the source disc media speed (default speed of disc), to read the source
disc.
The default value is: "MX".
• DVD READING SPEED
Set the reading speed of the source drive.
Usable speed can be: "MX", "01", "02", "2.4", "04", "06", "08, 16".
"MX" indicates the maximum speed. If you set this value to a value higher than the maximum
speed of your writer, your writer will operate at its maximum speed.
"MD" the reader uses the source disc media speed (default speed of disc), to read the source
disc.
The default value is: "MX".
• CD WRITING SPEED
Set the writing speed of your writers.
Usable speed can be: "MX", "MD, "01", "02", "03", "04", "06", "08", "10",
"12", "16", "20", "24", "32", "40" "46", "48", and "52".
"MX" indicates the maximum speed. If you set this value to a value higher than the maximum
speed of your writer, your writer will operate at its maximum speed.
"MD" the writers use the source disc media speed (default speed of disc), to read the source
disc.
The default value is: "MX".
• DVD WRITING SPEED
Set the writing speed of your writers.
Usable speed can be: "MX", "MD, "01", "02", "2.4", "04", "06", "08"
"MX" indicates the maximum speed. If you set this value to a value higher than the maximum
speed of your writer, your writer will operate at its maximum speed.
"MD" the writers use the source disc media speed (default speed of disc), to read the source
disc.
The default value is: "MX".
• SET AS DEFAULT
The Kanguru DVD controller will save all changes of the settings made. If you want to restore the
factory setting (default setting) push the "SET" button to select this setting and then push the
"RUN" button to restore the default settings.