Kanguru DVD Autoloader 200 User Manual page 17

Adjust the arm so that the disc hole is located directly below the sucker on the arm.
•
ADJ ANGLE OF 1 SPDL
This allows you to move the pickup position to the left or the right for the first spindle
drive. Press SET to move the arm to the left or RUN to move the arm to the right. Press
and HOLD SET to exit.
Use the included peg to align the arm with the center of the spindle.
•
ADJ ANGLE OF 2 SPDL
Same as ADJ ANGLE OF 1 SPDL.
•
ADJ ANGLE OF 3 SPDL
Same as ADJ ANGLE OF 1 SPDL.
•
ADJ ANGLE OF 5 SPDL
Same as ADJ ANGLE OF 1 SPDL.
•
ADJ DOWN LMT OF SPDL
This allows you to adjust pickup position up or down for the Disc Bins. You only need to
calibrate one bin for this function. Press SET to move the arm up or RUN to move the
arm down. Press and HOLD SET to exit.
The best way to calibrate this setting is to place one disc at the bottom of the bin and
move the arm down until it rests snug against the disc.
•
DLY AFTER FINISH:
You can adjust the period the duplicator will wait between duplication sets.
•
DLY BETWEEN DRVS:
You can adjust the period the duplicator will wait to move between drives.
•
SHORT TRAY [ yes ]
DO NOT change this setting unless instructed by a Kanguru technician.