Jumpers; Jumper Description; Jumper List - Advantech RSB-4411 User Manual

3.5" sbc with nxp i.mx6 processor arm cortex a9 architecture

Table of Contents

2.1

Jumpers

2.1.1

Cards can configured by setting jumpers. A jumper is a metal bridge used to close an

electric circuit. It consists of two metal pins and a small metal clip (often protected by

a plastic cover) that slides over the pins to connect them. To close a jumper, you con-

nect the pins with the clip. To open a jumper, you remove the clip. Sometimes a

jumper will have three pins, labeled 1,2 and 3. In this case you would connect either

pins 1 and 2 or 2 and 3.

The jumper settings are schematically depicted in this manual as follows.

A pair of needle-nose pliers may be helpful when working with jumpers. If you have

any doubts about the best hardware configuration for your application, contact your

local distributor or sales representative before you make any changes.

Generally, you simply need a standard cable to make most connections.

2.1.2

Table 2.1: Jumper List

LVDS_VDD_SLT

LVDS_BKLT_SLT

SW2

SW3

RSB-4411 User Manual

LVDS Power

Backlight Power

Boot device

RS-232/422/485 selection

Table of Contents