Table of Contents
Advertisement
®
EZ-SCREEN
LS Safety Light Screen
6.5.6 Generic Wiring Diagram—8-pin Receiver and IM-T-9A Interface Module
8-pin male
M12/Euro-style
(face view)
* Installation of transient (arc) suppressors across the coils of MPCE1 and MPCE2 is recommended (see WARNING).
** Scan Code 1: not connected or connected to 0 V dc (as shown). Scan Code 2: connect to 24 V dc.
*** Other interfacing modules and solutions available. See the Banner Engineering catalog or website for more information.
Note: See the IM-T-..A module datasheet (p/n
WARNING: Use of Transient Suppressors
If transient suppressors are used, they MUST be installed across the coils of the machine control
elements. NEVER install suppressors directly across the contacts of the IM-T-..A Module. It is possible
for suppressors to fail as a short circuit. If installed directly across the contacts of the IM-T-..A Module, a
short-circuit suppressor creates an unsafe condition. Failure to follow these instructions could result in
serious injury or death.
58
Bn (Pin #1)
Gn/Ye (#7)
Bu (#6)
Bk (#5)
Wh (#4)
Scan Code **
Vi (#8)
Or (#3)
Fault Out
Or/Bk (#2)
Figure 40. Generic Wiring Diagram—IM-T-9A Interface Module (1-Channel EDM)
www.bannerengineering.com - Tel: +1.763.544.3164
+24V dc
IM-T-9A ***
S3
K2
S4
Y3
Y1
13
23
Machine
Control
33
Feedback (optional)
62822
) for complete installation instructions.
0V dc
S1
K1
S2
Y4
Y2
14
MPCE
1
*
24
MPCE
2
34
*
Advertisement
Table of Contents
