The Evoke Accessory Belt; Wearing The Ecls With The Accessory Belt - SALUDA MEDICAL Evoke SCS User Manual

2. Plug the power adapter into a power outlet.
Caution: Be sure to plug the power adapter into a power outlet that is easy to
access.
3. Connect the Charger to the power adapter.
4. The Charger battery level indicator will flash one to four bars every second while
recharging the Charger.
5. When recharge is complete, the Charger will beep, and the 'Charger Battery Level'
indicator will show four full bars (refer to Section 8.2 'Charger Battery Level indicator').
Caution: Do not leave the Charger power adapter plugged into a power outlet after
recharging is complete.
Caution: You cannot recharge your Charger while you are using it to charge the
stimulator. You must remove the power adapter from the Charger before using it to
charge a stimulator.

9 The Evoke Accessory Belt

9.1 Wearing the eCLS with the Accessory Belt

During the trial stimulation period, you may wear an Accessory Belt to hold the eCLS. Place the
eCLS into the Accessory belt using the following steps.
1. Place eCLS into the Accessory Belt pouch with the leads exiting the pouch at the top
(Figure 9.1).
2. Close the pouch by pressing the Velcro sides together. The Velcro will fasten around the
leads exiting the pouch.
3. Wrap the elasticated portion of the belt around your waist and attach its Velcro end to
either the pouch or the belt itself. The belt should fit comfortably and securely around
your waist.
4. Position the belt so that there is no pulling or tension between the eCLS and the leads.
5. To remove the Accessory Belt, hold the pouch and lift the Velcro on the elasticated belt
to separate it from the pouch or belt.
Caution: To avoid pulling or tension between the eCLS and the leads, the belt
should not be moved during the trial (see Section 5 'Temporary trial stimulation'). Please
contact your clinician if you need to adjust the eCLS or belt.
CLIN-UMAN-005176
Evoke® SCS System User Manual
Revision: 4.01 Page 32 of 53