SALUDA MEDICAL Evoke SCS User Manual page 19

4. Orient the eCLS (with lead adapters connected) so that the battery is facing up and the
leads are exiting from the top.
5. Place the eCLS into the left side of the eCLS case (i.e. the orange seal side of the open
eCLS case; see Figure 5.3).
6. Place the leads into the slots in the seal at the lead exits.
Battery
Orange seal
Figure 5.3: Place the eCLS with leads connected into the eCLS Case.
7. While taking care to keep the leads in the slots in the seal, close the eCLS case by folding
the case shut until it snaps closed (see Figure 5.4).
Caution: The leads may be damaged when the case is closed if they are not in the
slots in the seal at the lead exits. This could disrupt your trial stimulation.
8. Secure the eCLS comfortably to your back using adhesive tape or the Evoke Accessory
Belt (See Section 9 'The Evoke Accessory Belt'). Avoid pulling on the leads or extensions,
or applying tension between the eCLS and the leads or extensions.
Figure 5.4 eCLS with two leads connected enclosed in the eCLS case.
CLIN-UMAN-005176
Evoke® SCS System User Manual
Lead exits
Revision: 4.01 Page 19 of 53