Wearing The Charger Coil With The Accessory Belt - SALUDA MEDICAL Evoke SCS User Manual

Figure 9.1: Inserting the eCLS into the Accessory Belt.

9.2 Wearing the Charger Coil with the Accessory Belt

The Accessory Belt can be used to hold the Charger coil in position when you are charging your
CLS. Follow the steps below to use the Accessory Belt with your Charger:
1. Place the Charger coil into pouch of Accessory Belt with cable exiting the pouch at the
top (Figure 9.2).
2. Close the pouch by pressing the Velcro sides together. The Velcro will fasten around the
cable or leads exiting the pouch.
3. Wrap the elasticated portion of the belt around your waist and attach its Velcro end to
either the pouch or the belt itself. The belt should fit comfortably and securely around
your waist.
4. Follow the Charger instructions (see Section 8.2) to charge the CLS.
5. Adjust the belt position if you need to re-align the Charge coil to the CLS.
6. When finished charging, remove the Accessory Belt by holding the pouch and lifting the
Velcro on the elasticated belt to separate it from the pouch or belt.
7. The Accessory Belt is a re-usable item and may be machine washed at low temperature.
CLIN-UMAN-005176
Evoke® SCS System User Manual
Revision: 4.01 Page 33 of 53