SALUDA MEDICAL Evoke SCS User Manual page 18

Figure 5.2: The Lead Adapter and eCLS. Port 2 of the eCLS is shown here. Port 1 is on the other
5.5.4.2 Reconnecting the eCLS
Caution: Saluda Medical does not recommend that you attempt to disconnect or
reconnect your eCLS without assistance.
Caution: Please follow the advice of your clinical team. If you wish to disconnect or
reconnect your eCLS, only do so with assistance from a care-giver following the
instructions below. Do not pull on the leads or extensions or apply tension between the
eCLS and the leads.
If you need to reconnect the lead adapters to the eCLS, please contact the clinic.
If your clinician instructs you to have a care-giver reconnect the components, they should:
1. Rest the lead adapter on the guide on the side of the eCLS and gently push the lead
adapter plug into the socket on the eCLS port until it clips into place (see Figure 5.2).
Note: The eCLS ports are labelled "1" on one side for lead 1 and "2" on the other side for
lead 2.
Note: Each lead adapter must be connected to the same port it was disconnected from.
If you feel stimulation has changed after reconnecting the components, your leads may
have been connected to the wrong eCLS port. If your stimulation has changed or you
have any issues, contact your clinic.
2. To reconnect the second lead adapter, repeat step 1.
3. Open the eCLS case and orient it as shown below (see Figure 5.3), with the orange seal
side on the left and the lead exits on the top.
CLIN-UMAN-005176
Evoke® SCS System User Manual
side of the eCLS.
Revision: 4.01 Page 18 of 53