Table of Contents
Advertisement
Installation or Removal of the Support Rails
Figure 5-3 Support Rail Installation
The embossings at [2] and [5] act as lateral guides for the support rails, while the embossings
at [1] and [6] secure the support rails in place. For the support rails to install correctly the
retaining spring [3] must be facing upwards.
1. Place the support rail [4] on the lower embossing [6] and tilt it upwards against the work
space side wall so that the rail is positioned over the two embossings at [5] and [2].
2. Clamp the retaining spring [3] behind the upper embossing [1].
3. To remove the support rails, pull the retaining spring tab down out of the embossing and
remove the support rail assembly.
Fisher Scientific
For details about the cleaning and disinfection of the low temperature
incubator, please refer to
Cleaning and disinfection
"Cleaning"
on
page
9-1.
Peltier Low Temp. Incubators
Installation procedures
Preparing the usable space
5-3
Advertisement
Table of Contents
