Table of Contents
Advertisement
Preparing the Manual Wipe/Spray Disinfection
Predisinfection
1. Remove all samples from the work space and store them in a safe place.
2. Spray disinfectant onto the surfaces of the work space and of the accessories or wipe the surfaces
clean using disinfectant.
3. Allow time for the disinfectant to act as specified by the manufacturer.
Fisher Scientific
The surfaces of the work space may be contaminated. Contact
with contaminated cleaning liquids may cause infections.
Disinfectants may contain harmful substances.
When cleaning and disinfecting, always observe the safety
instructions and hygiene guidelines!
• Wear safety gloves.
• Wear safety goggles.
• Wear mouth and respiratory system protection gear to protect your
mucous membranes.
• Observe the safety instructions of the disinfectant's manufacturer
and the hygiene supervisor.
The glass panel may only be removed by properly trained and
authorized specialists.
The glass panel must be held by two persons.
Spray the sensor and other hard-to-reach components with
disinfectant!
Check to ensure that the air baffles are securely screwed into place
after cleaning and moving the unit.
Cleaning and Disinfection
Wipe / Spray Disinfection
Health hazard
Risk of injury caused by breaking of
glass panel
Disinfecting hard-to-reach components
Peltier Low Temp. Incubators
9-3
Advertisement
Table of Contents
