Installing And Uninstalling The Air Baffle; Figure 5-4 Removing The Air Baffle - Fisher Scientific Isotemp 178L 120V User Manual

Installation procedures
Preparing the usable space

Installing and Uninstalling the Air Baffle

Fisher Scientific low temperature incubators are shipped from the factory with the air baffle
readily pre-installed. Before the air baffle can be removed from the back wall, the support rails
need to uninstalled.

Figure 5-4 Removing the Air Baffle

1. Losen the two screws [1] that hold the air baffle to the interior container back wall.
2. Grab the two retaining springs [2] at their tabs and the cut-out of the access port and pull
them downwards out of the embossings, then take off the air baffle from the back wall.
3. For the air baffle to install correctly, the retaining springs must be facing upwards. Place the
air baffle on the lower embossings and tilt it upwards against the back wall of the work space.
4. Clamp the two retaining springs [2] into the upper embossings.
5. Secure the air baffle against the interior container back wall by fastening the two screws at [1].
Levelling the low temp. incubator
1. Position a bubble level onto the center shelf.
2. Manually adjust the levelling feet until the shelf is horizontally aligned in all directions.
Perform the adjustment of the levelling feet from left to right and from rear to front.
5-4 Peltier Low Temp. Incubators Fisher Scientific