Commissioning of floor stand low temp. incubators
Installing/Removing air baffles (381L Series)
The section below describes how to install/remove the bottom plate.
Figure 5-5
1. Loosen and remove the four (4) screws in the bottom plate and then remove the bottom
plate completely.
Figure 5-6
Loosen and remove the eight (4) screws for the left and right support profiles and then take
out the lateral air baffles.
Check to ensure that the air baffles are securely screwed into place after cleaning and moving
the unit.
Fisher Scientific
Removing the bottom plate
Removing the left and right support profiles
Commissioning of floor stand low temp. incubators
Peltier Low Temp. Incubators
Installation procedures
5-5