Table of Contents
Advertisement
Work Space Components
Inner Chamber
All components of the work space are made of corrosion-resistant stainless steel and have an
absolutely smooth and easy-to-clean surface. Any embossings have a large radius.
Access Port
A re-sealable, capped access port (can be closed off using the plugs delivered with the unit)
allows cables, hoses or additional sensor leads to be routed into the work space of the low
temperature incubator.
The access port [2] has a diameter of 42 mm.
Figure 4-11 Access Port
Fisher Scientific
When accessories are to be operated in the work space of the low
temperature incubator, the ambient condition requirements must be
observed (see table below). The energy introduced into the work space
has an impact on the lower end of the temperature control range. When
additional heating sources are introduced into the work space,
temperature control may be adversely affected.
It is recommended to close the access port as much as possible after
inserting cable, hose, additional sensor to keep air exchange via the
port to a minimum.
Work Space Components
Operating conditions
Peltier Low Temp. Incubators
Product Description
4-11
Advertisement
Table of Contents
