Cleaning and Disinfection
Cleaning
Cleaning Exterior Surfaces
Remove dirt residues and depositions thoroughly using a solution of lukewarm water and
commercial detergent.
Wipe the surfaces clean using a clean cloth and clear water.
Then, wipe the surfaces dry using a clean cloth.
Wipe / Spray Disinfection
The manual wipe and spray disinfection is a three-stage process:
• predisinfection,
• cleaning,
• final disinfection.
Fisher Scientific
Some low temperature incubator components are made of plastics.
Solvents may attack plastics. Strong acids or alkaline solutions
may cause embrittlement of plastics.
Do not spray cleaning agent onto the control panel and the
interfaces at the rear of the low temperature incubator. When
wiping the low temperature incubator clean, always make sure that
no moisture enters into these components.
Wipe the display window down with a slightly dampened cloth,
then wipe dry with a rag made of 100% microfiber.
Incompatible cleaners
Moisture-sensitive components
Peltier Low Temp. Incubators
9
9-1