Changing The Link Configuration Of The Services Appliance - NetApp StorageGRID 11.5 Hardware Installation And Maintenance Manual

Hardware Installation and Maintenance Guide for SG100 and SG1000 Appliances
Maintaining the appliance
ii. Place the drive on a
static-free, level surface.
The handle on the drive springs open partially, and the drive releases from the slot.
5. Open the handle, slide the drive out, and place it on a static-free, level surface.
6. Press the release button on the replacement drive before you insert it into the drive slot.
The latch springs open.
i. Insert the drive.
7. Insert the replacement drive in the slot, and then close the drive handle.
When the drive is fully inserted, you hear a click.
The drive is automatically rebuilt with mirrored data from the working drive. You can check
the status of the rebuild by using the Grid Manager. Select Nodes. Then select
> Hardware. The Storage RAID Mode field contains a "rebuilding" message until the
Node
drive is completely rebuilt.
8. Contact technical support about the drive replacement.
Technical support will provide instructions for returning the failed drive.

Changing the link configuration of the services appliance

You can change the Ethernet link configuration of the services appliance. You can change the port
bond mode, the network bond mode, and the link speed.
Before you begin
• You must place the appliance in maintenance mode. Putting a StorageGRID appliance into
maintenance mode might make the appliance unavailable for remote access.
Placing an appliance into maintenance mode
ii. Close the drive tray handle.
Note: Do not use excessive force
while closing the handle.
Attention: Do not use excessive force while closing
the handle.
i. Press the
release button.
Attention: Ensure
that the tray handle
is fully open before
you attempt to slide
the drive out.
on page 78
Appliance
90