Table of Contents
Advertisement
12 Electrical connection
12
Electrical connection
Note! The installation shall be made according to local codes.
When working in, with or around electrical circuits, all power must be disconnected.
12.1
Connection box, single door
Fit the connection box in the back plate.
Note! To ensure for sufficient grounding, the square nuts must be turned with the teeth upwards
against the box so that they cut through the anodizing in the back plate.
a Switch off the electrical power.
b Unscrew the lid.
c Strip approximately 5 inches off from the outer insulation of the power installation cable (2).
d Insert the free end of the power installation cable into the connection box (3) through the
metal strain relief (4).
e For the following connections: Use twist-on wire connectors ("wire nuts") (5), that are approved
for the application. The wires should be stripped according to the instructions for the used wire
connector. Be aware, local code shall be followed.
• Connect the (white) neutral wire of the power installation cable with the AWG18 (white)
neutral wire that extends from the CPD metal housing (6).
• Connect the (black) phase wire of the power installation cable with the free AWG18 (black)
wire of the cable of the rocker switch assembly (7).
• Connect the solid green earth wire (8), that is attached to the bottom of the connection
box, with the green earth wire of the power installation cable (2), and the green earth wire
of the interconnection cable (9).
f
Tuck the slack of the wires into the largest compartment, between the CPD metal housing (6)
and the wall of the connection box. Be careful not to place connectors, or excessive loops of
wire, on top of the CPD metal housing as they might interfere with the fastening of the cover.
g Fasten the lid (1) of the connection box.
2
4
50
5
8
3
5
6
Issue 2013-02-10
9
7
1009937-EI-1.0
Advertisement
Table of Contents
