ProLights V200SPOT User Manual page 29

3.13 Master display mode
In the master display mode e. g. the most important control functions of the V200SPOT can be checked
without DMX controller.
1. Press the button MENU (2) so many times until the display shows
Note: if no button is pressed for 8 seconds, the unit switches back to the previous operating mode!
2. Select the control function with the button DOWN or UP (3):
Panning of pan head
Tilting of pan head
Shutter control
Dimmer
Gobo
Colour
R- Gobo
3. To activate the function, press the button ENTER (4).
4. Adjust the DMX value with the button DOWN or UP. The unit responds immediately.
5. After pressing the button ENTER again, it is possible to select another control function with the button
DOWN or UP.
6. To stop the master display mode, do not actuate any button for 8 seconds.
3.14 Display of the working hours
To show the state of the working hour meter:
a) Press the button MENU (2) so many times until
b) Press the button ENTER (4). The working hours are displayed.
c) After 8 seconds the unit switches back to the previous operating mode.
3.15 Display of the firmware version
To display the version number of the firmware (operating system of the light effect unit):
a) Press the button MENU (2) so many times until
b) Press the button ENTER (4). The version number is displayed.
c) After 8 seconds the unit switches back to the previous operating mode.
3.16 Reset
In case of malfunctions it may be possible to eliminate them by a reset of the unit:
a) Press the button MENU (2) so many times until
appears in the display (1).
b) Press the button ENTER (4). The moving head and all control motors go to a defined starting position.
Meanwhile the display indicates. Then the unit switches back to the previous operating mode.
V200SPOT
(fixture hours) appears in the display (1).
(version) appears in the display (1).
(reset) appears in the display (1).
(master display mode).
(fixture hours)
13