Rip Overview; Rip - ZyXEL Communications LTE Series User Manual

8.5 RIP O ve rvie w
Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows the Zyxel Device to exchange routing
information with other routers. To activate RIP for the WAN interface, select the supported RIP version
and operation.

8.5.1 RIP

Click
Ne two rk Se tting > Ro uting > RIP
operation by clicking the check box. To stop RIP on the WAN interface, clear the check box. Click the
button to start/stop RIP and save the configuration.
Apply
Network Setting > Routing > RIP
Fig ure 79
The following table describes the labels in this screen.
Table 32 Network Setting > Routing > RIP
L ABEL
#
Interface
Version
Operation
Enable
Disable Default
Gateway
Cancel
Apply
Chapter 8 Routing
to open the
DESC RIPT IO N
This is the index of the interface in which the RIP setting is used.
This is the name of the interface in which the RIP setting is used.
The RIP version controls the format and the broadcasting method of the RIP packets that the
Zyxel Device sends (it recognizes both formats when receiving).
but carries more information.
RIPv2
have an unusual network topology. When set to
table periodically and incorporate the RIP information that it receives
Select to have the Zyxel Device update the routing table based on the RIP packets
Pa ssive
received from neighbors but not advertise its route information to other routers in this interface.
Select to have the Zyxel Device advertise its route information and also listen for routing
Ac tive
updates from neighboring routers.
Select the check box to activate the settings.
Select the check box to set the Zyxel Device to not send the route information to the default
gateway.
Click to exit this screen without saving.
C a nc e l
Click to save your changes back to the Zyxel Device.
Apply
LTE Series User's Guide
screen. Select the desired RIP version and
RIP
is probably adequate for most networks, unless you
RIPv1
, the Zyxel Device will broadcast its routing
Bo th
105
is universally supported
RIPv1