Cellular Lock - ZyXEL Communications LTE Series User Manual

Table 20 Network Setting > Broadband > Cellular IP Passthrough (continued)
L ABEL
Passthrough
Mode
Passthrough
to fixed MAC
Apply
Cancel
6.9 C e llula r L o c k
Cellular Lock locks the CPE to the base station that it is currently connected to. This is useful if the CPE is
within range of multiple base stations, and you would prefer the CPE to connect to one base station
over the others.
Click
Ne two rk Se tting > Bro a db a nd > C e llula r L o c k

Cellular Lock

Fig ure 48
The following table describes the fields in this screen.
Table 21 Cellular Lock
L ABEL
PCI Lock
Add New Rule
Physical Cell ID
RFCN
Chapter 6 Broadband
DESC RIPT IO N
Select to allow traffic to be forwarded to any LAN computer on the local network of the
Dyna m ic
Zyxel Device. Select to allow traffic to be forwarded to a specific LAN computer on the local
Fixe d
network of the Zyxel Device.
Note: This field will show upon enabling
Enter the MAC address of a LAN computer on the local network of the Zyxel Device upon
selecting in the previous field.
Fixe d
Note: This field will show upon selecting
Click this to save your changes.
Click this to exit this screen without saving.
DESC RIPT IO N
Select this to enable or disable PCI (Physical Cell Identifier) Lock.
Select this if you want to add a new rule or to configure cellular lock rules.
Use this to enter the PCI number of the base station you choose to connect to
(0~504).
Use RFCN (Radio Frequency Channel Number) to enter the LTE frequency of the
selected PCI number(1~65535).
LTE Series User's Guide
IP Pa ssthro ug h
in the previous field.
Fixe d
. The following screen displays.
74
in the previous field.