Rip Overview - ZyXEL Communications NR/FWA Outdoor Series User Manual

Figure 104 Network Setting > Routing > Policy Route: Add or Edit
The following table describes the labels in this screen.
Table 52 Network Setting > Routing > Policy Route: Add or Edit
LABEL
Active
Route Name
Source IP
Address
Source Subnet
Mask
Protocol
Source Port
Source MAC
Source Interface
(example: br0 or
LAN1 – LAN4)
WAN Interface
Cancel
OK

10.5 RIP Overview

Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows the Zyxel Device to exchange routing
information with other routers. To activate RIP for the WAN interface, select the supported RIP version
and operation.
Chapter 10 Routing
DESCRIPTION
Click this switch to activate this policy route. Otherwise, click to disable.
Enter a descriptive name of this policy route. You can use up to 15 printable characters except [
" ], [ ` ], [ ' ], [ < ], [ > ], [ ^ ], [ $ ], [ | ], [ & ], or [ ; ]. Spaces are allowed.
Enter the source IP address.
Enter the source subnet mask address.
Select the transport layer protocol (TCP, UDP, or None).
Enter the source port number.
Enter the source MAC address.
Enter the name of the interface from which the matched traffic is sent.
Select a WAN interface through which the traffic is sent. You must have the WAN interfaces
already configured in the Broadband screens.
Click Cancel to exit this screen without saving.
Click OK to save your changes.
NR/FWA Outdoor Series User's Guide
154