Divide Function - JVC CA-MXS6MDR Instructions Manual

DIVIDE Function

This function allows you to divide one track into two
separate tracks. It is useful, for example, when you want to
add track marks at a certain point within a track or if you
want to separate a recording.
• To stop any time during editing process, press TITLE/
EDIT.
1
Insert an MD you want to edit into the MD loading
slot.
• It takes about 5 seconds for the unit to read the TOC
(Table Of Contents) of the inserted MD. While the
unit is reading it, you cannot go to the next step.
2
Press TITLE/EDIT.
The source is changed to "MD."
• If "DIVIDE" is not shown, you cannot divide the
track.
3
Push the joy control downward ( ) to select
"DIVIDE" (highlighted), then press SET.
The first track (or the current track) starts playing.
4
Push the joy control rightward ( ) or leftward ( )
to select the track you want to divide.
The selected track starts playing.
Ex. When you want to divide track 5
If the track has a title, it is shown here.
• If you do not push the joy control rightward (¢ )
or leftward (4 ), the same track plays repeatedly.
• You can push and hold the joy control upward (¡
) or downward (1 ) to find the dividing point.
– 43 –
5
Press SET when you find the point where you want
to divide the track.
The MD recorder repeats the selected point
— a 3-second period following the dividing point.
• If the dividing point is satisfactory, go to step 7 .
• If the dividing point is not satisfactory, go to the next
step.
6
Push and hold the joy control rightward ( ) or
leftward ( ) to precisely adjust the dividing point.
• You can shift the dividing point up to ±128. This
range (±128) corresponds to approximately ±8
seconds from the original point (Position 0).
Ex. When adjusting the point by +20
When you stop holding the joy control, the unit
repeats the newly selected dividing point.
• When you find the right position, go to the next step.
• If you want to cancel the dividing point, press
CANCEL, then select the correct dividing point.
7
Press SET.
8
Press ENTER/DEMO to finish the editing
procedure.
"EDITING" appears for a while, then "WRITING"
flashes while the editing you have made is being
recorded on the MD.
To join the divided tracks again, see the JOIN function.