JVC CA-MXS6MDR Instructions Manual page 53

Changing the Title
You can make a correction or change the title.
1
Follow steps 1 to 5 of page 48.
2
Select the character you want to correct, referring to
step 7 on page 49.
• Make sure that the character you want to change is
flashing.
3
Press CANCEL to delete the character you have
selected in the above step.
4
Input the correct character, referring to step 7 on
page 49.
5
Repeat steps 2 to 4 of the current procedure to
correct more characters.
6
Press ENTER/DEMO to finish correcting the title.
• If you want to correct another title, select another title
entry mode by pushing the joy control rightward ( )
or leftward ( ), press SET, then repeat from step 2
above.
• If you want to finish the correction, go to the next
step.
7
Press TITLE/EDIT (or ENTER/DEMO again) to
exit from the title entry mode.
8
Press 0 for the MD recorder to eject the MD.
"WRITING" flashes while the editing you have made is
being recorded on the MD.
To erase all the characters
Press CANCEL repeatedly in step 3 above to erase all the
characters, then go to step 6 .
On the remote control:
In the following example, the process is explained from the
very first — that is, inserting a disc. If you have already
started recording or playing, start from step 3 .
• To exit from the title entry screen any time during the
process, press MD TITLE.
1
Insert an MD you want to edit into the MD loading
slot.
2
Press MD 3 / 8, then 7.
The source is changed to "MD."
3
Press MD TITLE.
The MD recorder enters one of the following title entry
screen.
• Disc title entry screen: appears when you press MD
TITLE when the MD recorder stops.
• Track title entry screen: appears when you press
MD TITLE while playing, pausing, or recording.
4
Press ø (10) or Ø (+10) to change the title entry
mode.
EX. When track 8 is selected
• Title entry mode changes as follows:
Disc
title
Last track
title
– 50 –
Continued
2nd track
1st track
title
title
3rd track
title