Join Function; Move Function - JVC CA-MXS6MDR Instructions Manual

JOIN Function

This function allows you to join two adjacent tracks into
one track.
• To stop any time during editing process, press TITLE/
EDIT.
1
Insert an MD you want to edit into the MD loading
slot.
• It takes about 5 seconds for the unit to read the TOC
(Table Of Contents) of the inserted MD. While the
unit is reading it, you cannot go to the next step.
2
Press TITLE/EDIT.
The source is changed to "MD."
• If "JOIN" is not shown, you cannot join the tracks.
3
Push the joy control downward ( ) to select
"JOIN" (highlighted), then press SET.
4
Push the joy control downward ( ) or upward ( )
to select the two adjacent tracks you want to join.
Ex. When you want to join tracks 2 and 3
5
Press SET.
• If you have selected wrong tracks, press CANCEL,
then select the correct tracks.
6
Press ENTER/DEMO to finish the editing
procedure.
"EDITING" appears for a while, then "WRITING"
flashes while the editing you have made is being
recorded on the MD.
To divide the joined tracks, see the DIVIDE function.
If "CANNOT JOIN" appears in step
You cannot join the following tracks.
• Tracks recorded using different recording length modes (LONG
MODE — SP/LP2/LP4). (See page 35.)
• Digital-recording tracks and analog-recording tracks.
• Tracks recorded using monaural long recording method (not
possible on this unit) and stereo-recording tracks.

MOVE Function

This function allows you to move a track to the position
you prefer. It is useful to change the order of the tracks as
you like.
• To stop any time during editing process, press TITLE/
EDIT.
1
Insert an MD you want to edit into the MD loading
slot.
• It takes about 5 seconds for the unit to read the TOC
(Table Of Contents) of the inserted MD. While the
unit is reading it, you cannot go to the next step.
2
Press TITLE/EDIT.
The source is changed to "MD."
• If "MOVE" is not shown, you cannot move the track.
– 44 –
Continued
5