External Source Setting - JVC CA-MXS6MDR Instructions Manual

2
Push the joy control downward ( ) to select
"CONTRAST ADJ.," then press SET.
• When shipped from the factory, contrast level is set to
+40.
3
Push and hold the joy control upward ( ) or
downward ( ) to adjust the contrast.
• You adjust the contrast within the range of +25 to
+64.
4
Press SET to finish the adjustment.
If you cannot see any indications on the display
The display contrast is too light. If this happens, unplug the AC
power cord and plug it again. The contrast will be reset to the
initial setting when shipped from the factory.

External Source Setting

Selecting the sound input level
This is only used for recording from analog sources (ex.
tape, VCR, or portable MD player) connected to the LINE
1 jacks and to the LINE 2 jack.
If the recorded sound from such an analog source is not
loud enough, or if it is distorted, select the appropriate
sound input level before recording.
• When the input level is too loud during recording, the
display turns red, the OVER indicator lights, and "Level
OVER!" appears.
• You cannot adjust the input level while recording.
1
Press MENU.
The menu screen appears in the main display.
• If the current source is not the external equipment
connected to the LINE 1 jacks or to the LINE 2 jack,
you cannot go to the next step.
2
Push the joy control downward ( ) to select
"INPUT Level," then press SET.
Ex. When the source is the external equipment
connected to the LINE 1 jacks
3
Push the joy control downward ( ) — or upward
( ) — to select the input level.
• When the source is the equipment connected to the
LINE 1 jacks:
Level 1 : Select when the recorded sound is not loud
enough. This setting increases the input
signal level. (Initial setting when shipped
from the factory)
Level 2: Select when the recorded sound is distorted.
This setting reduces the input signal level.
• When the source is the equipment connected to the
LINE 2 jack:
Level 1 : Initial setting when shipped from the
factory
Level 2: Select when the recorded sound is distorted
with "Level 1" selected.
Level 3: Select when the recorded sound is still
distorted with "Level 2" selected.
Level 4: Select when the recorded sound is still
distorted with "Level 3" selected.
• If "Level OVER!" still appears even after
setting the input level to "Level 4," reconnect
the equipment to the LINE 1 jacks, and set the
input level to "Level 2."
4
Press SET to finish the setting.
Changing the source name
You can change the external source names (LINE1, LINE2,
and DIGITAL IN) to the actual component names.
• You cannot change the external source names while
recording its sound on an MD.
1
Press MENU.
The menu screen appears in the main display.
• If the current source is not the external equipment
connected, you cannot go to the next step.
2
Push the joy control downward ( ) to select
"NAME CHANGE," then press SET.
Ex. When the source is the external equipment
connected to the LINE 1 jacks
– 65 –