Connecting Speakers - JVC CA-MXS6MDR Instructions Manual

AM antenna
1
2
AM loop antenna
(supplied)
1
If cords are covered with insulation, twist the core of
the cord at the end of each cord, then remove the
insulation.
2
Connect the AM loop antenna to the AM LOOP
terminals as illustrated.
3
Turn the AM loop antenna until you have the best
reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it horizontally.
(The AM loop antenna must remain connected.)
For better reception of both FM and AM (MW/LW)
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
Vinyl-covered
wire
(not supplied)
3

Connecting Speakers

You can connect the speakers using the speaker cords.
1
2
Red
Right
speaker
1
If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2
Open the speaker terminal.
3
Insert the end of the speaker cord to the terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
4
Close the speaker terminal on the rear of the unit.
Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
– 7 –
3 4
Black
Speaker cord
Left
speaker
Red