Table of Contents
Advertisement
3
Push the joy control downward ( ) — or upward
( ) — to select the source name.
• When the source is the external equipment connected
to the LINE 1 jacks:
You can select from "LINE1" (Initial setting),
"TAPE," "DBS," "VCR," "TV," and "GAME."
• When the source is the equipment connected to the
LINE 2 jack:
You can select from "LINE2" (Initial setting) and
"P-MD" (portable MD player).
• When the source is the equipment connected to the
DIGITAL IN terminal:
You can select from "DIGITAL IN" (Initial setting)
and "DBS-DIGITAL."
4
Press SET to finish the setting.
Auto Power Off Setting
Auto Power Off function automatically turns off the unit if
no sound comes in for more than 3 minutes.
If any operation is done during this 3-minute period, Auto
Power Off function is canceled temporarily even though no
sound comes in.
1
Press MENU.
The menu screen appears in the main display.
• If the unit is turned off, you cannot go to the next
step.
2
Push the joy control downward ( ) to select
"A.P.off (current setting*)."
* The current setting will appear following "A.P.off."
3
Push the joy control rightward ( ) or leftward ( )
to select either "SET" or "CANCEL."
SET :
Activates the Auto Power Off function.
CANCEL : Cancels the Auto Power Off function.
4
Press SET to finish the setting.
When Auto Power Off function is activated, the A.P.off
indicator lights on the display.
The A.P.off indicator starts flashing if no sound comes
in.
When the remaining time until the shut-off time
becomes 20 seconds, it will be shown in the main
display.
To store the display setting in memory
You can store the following display settings in
memory. So, even though the AC power is unplugged
or a power failure occurs, the settings are kept in
memory.
• Display demonstration off setting (see page 9)
• Level meter (see pages 13 and 63)
• Display color (see page 63)
On the unit ONLY:
1
Unplug the AC power cord.
2
Plug the AC power cord again while holding 7
and ENTER/DEMO at the same time.
3
Set the above settings as you like.
•
Turn off the display demonstration. (See
page 9.)
If you turn it off and store its setting in backup
memory, display demonstration will not start
even after the AC power cord is reconnected or
when a power failure is recovered.
•
Select the level meter. (See page 13 or 63.)
•
Select the display color. (See page 63.)
To erase the memory
Repeat steps 1 and 2 of the above procedure.
Memory is cleared.
• When the AC power plug is reconnected or a power
failure is recovered, display demonstration
automatically starts.
– 66 –
Hide quick links:
Advertisement
Table of Contents
