Basic Operating; Standby / On; Automatic Power Off Function; Selecting Modes - JVC TH-WL711B Instruction Manual

2.2ch wireless soundbar
Table of Contents

Advertisement

Basic Operating

Standby / ON

When you fi rst connect the unit to the mains socket, the unit will be in Standby mode.
During Standby mode, the display will show the current time and the Pair indicator
on subwoofer will blink slowly. Touch
switch the unit on, the display will show the last used mode. The sound level will be set
on level 25 if the sound is set higher than level 25 last time.
Touch
on the unit or press
Standby mode and the unit will display the current time.
• If a TV or an external device is connected to AUX socket, the main unit and the subwoofer will switch
on automatically when the TV or the external device is switched on.
BUT in the following cases, the unit will not switch on automatically in AUX mode:
− after automatic power off when SLEEP mode is set and activated (please refer to the section
"Setting the Sleep Timer" .
− after automatic power off function is activated. For details, please refer to the section "Automatic
Power Off Function" below.
• If 2 external devices are connected to both AUX sockets, the soundbar will switch to the fi rst audio
signal input detected automatically when the external devices are switched on.
Subwoofer
Press SUB ON / SUB OFF to turn the sound output On or Off for the subwoofer.
Automatic Power Off Function
The unit automatically turns to Standby mode after 15 minutes if the TV or the external
unit is disconnected or switched off in HDMI and Optical mode or the volume is too close
to mute in AUX, Bluetooth® mode.
• To switch the unit off completely, remove the mains plug from the mains socket.
• Please turn the unit off completely to save energy when not in use.

Selecting Modes

Press SOURCE on the unit repeatedly to switch between BT (Bluetooth®), OPT (Optical),
HDMI1, HDMI2, TV ARC, AUX1 and AUX2 modes. The selected mode will show on the
display.
Alternatively directly press BT, OPT, HDMI 1, HDMI 2, ARC, AUX 1 and AUX 2 on the remote control to
select the desired mode.
on the unit or press
on the remote control again to switch the unit back to
on the remote control to
19

Advertisement

Table of Contents
loading

Table of Contents