Divide Function - JVC CA-MD70 Instructions Manual

Continued
Amplifier/tuner
MD recorder
MD IN lamp

DIVIDE Function

This function allows you to divide one track into two
separate tracks. It is useful, for example, when you want to
add track marks at a certain point within a track or if you
want to separate a recording.
• To do the following procedures, use the buttons and
controls on the unit.
• To stop any time during editing process, press MD EDIT.
1
Insert an MD you want to edit into the MD loading
slot.
The MD IN lamp lights.
2
Press MD EDIT.
The MD recorder enters editing mode (with DIVIDE
function selected).
3
Press SET.
The information of the first track (or the current track,
if during play) of the MD appears in the main display,
and playback starts.
4
Rotate MULTI JOG to select the track you want to
divide.
Ex. When you want to divide track 3
MD EDIT SET
CANCEL
MD Loading slot
– 29 –
MULTI JOG
ENTER
0
• If you have selected a wrong track, press CANCEL
then select the correct track.
5
Press SET when you find the point where you want
to divide the track.
The MD recorder repeats the selected point — a
portion of 3 seconds length following the dividing
point.
• If the dividing point is satisfactory, go to step 7.
• If the dividing point is not satisfactory, go to the next
step
6
Rotate MULTI JOG to precisely adjust the dividing
point.
• You can shift the dividing point up to ±128. This
range (±128) corresponds to approximately ±8
seconds from the original point (Position 0).
When you stop rotating the MULTI JOG dial, the unit
repeats the newly selected dividing point.
• When you find the right position, go to the next step.