Wireless Guidelines - Technogym SKILLRUN UNITY 5000 Instructions Manual

NOTE: The Protocol WPA2 Enterprise is not supported.
_There must be only one dedicated Access Point / Wi-Fi router that provides the service;
_ DHCP enabled;
In case of professional Access Point or if the equipment is used in a public / company network
(hotel, fitness facility) you must cover the following additional requirements:
_Configure the Access Point to broadcast only one SSID (Service Set Identifier) needed for the
equipment installation. The SSID must not be hidden;
_Program in the display of equipment (Customer Menu 2406: Network: Wi-Fi) just only the SSID
defined above;
_ Frequency Band:
▪ 5GHz band only (not automatic) is the configuration suggested;
▪ If the Access Point is not provided with 5GHz band, 2.4GHz is ok but might need some chan-
nel fine tuning by the local IT company. The best practice for 2.4GHz Wi-Fi configuration is
enabling Wi-Fi on one of the following channels: 1, 6, 7, 8, 9, 10, 11, 12. Other channels: 2,
3, 4, 13, 14 might cause interference with Bluetooth signal.
▪ Avoid in any case to broadcast the same SSID through 2.4 and 5 GHz at the same time.
_ LEASE TIME : at least three days;
_ SESSION TIMEOUT disabled (Typically achieved setting the timeout = 0).
For more details about Access Point, refer to the AP technical specifications.

5.5 WIRELESS GUIDELINES

The following indications must be interpreted only as guidelines.
The wireless network must be installed and configured only by specialised companies and expert
technicians.
_The equipment must not be more than 25-30 metres LOS (line of sight) away from the Access
Point (analyse possible problems due to the presence of walls or other obstacles between the Ac-
cess Point and the equipment).
_If you use an Access Point with a fixed channel: avoid overlapping problems if, in the same area,
there are Access Points that use the same channel.
- 22 -
SKILLRUN (DJJ) Pre-Installation Requirements
Rev. 2.0