Replacing The Fuses - Yamaha MT-10 2019 Owner's Manual

Periodic maintenance and adjustment
battery tends to discharge more quickly
1
if the vehicle is equipped with optional
electrical accessories.
2
NOTICE
To charge a VRLA (Valve Regulated
3
Lead Acid) battery, a special (con-
stant-voltage) battery charger is re-
4
quired. Using a conventional battery
charger will damage the battery.
5
To store the battery
6
1. If the vehicle will not be used for
more than one month, remove the
battery, fully charge it, and then
7
place it in a cool, dry place.
NOTICE: When removing the
8
battery, be sure to turn the main
switch off, then disconnect the
9 negative lead before discon-
necting the positive lead.
2. If the battery will be stored for more
10
than two months, check it at least
once a month and fully charge it if
11
necessary.
3. Fully charge the battery before in-
stallation. NOTICE: When install-
12
ing the battery, be sure to turn
the main switch off, then con-
nect the positive lead before
connecting
lead.
ECA16522
[ECA16842]
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals.
NOTICE
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
[ECA16304]

Replacing the fuses

the negative
The main fuse and ABS motor fuse are
located
page 4-22.)
ECA16531
1. Main fuse
2. ABS motor fuse
3. ABS motor spare fuse
4. Starter relay cover
TIP
Remove the starter relay cover by pull-
ing it upward.
7-30
EAU73994
under the seat. (See
1
4
2
3