Table of Contents
Advertisement
switch off, then disconnect the
negative lead before discon-
necting the positive lead.
2. If the battery will be stored for
more than two months, check it at
least once a month and fully
charge it if necessary.
3. Fully charge the battery before in-
stallation. NOTICE: When install-
ing the battery, be sure to turn
the main switch off, then con-
nect the positive lead before
connecting the negative lead.
[ECA16842]
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals.
NOTICE
Always keep the battery charged.
Storing a discharged battery can
cause permanent battery damage.
Periodic maintenance and adjustment
Replacing the fuses
The main fuse and the fuse boxes,
[ECA16304]
which contain the fuses for the individ-
ual circuits, are located under the rider
seat (XTZ690/XTZ690-U) (See page
4-22.) or the seat (XTZ690-B/XTZ690-
UB) (See page 4-21.).
TIP
To access the main fuse, remove the
starter relay cover as shown.
2
ECA16531
1
1. Starter relay cover
2. Fuse box
3. Spare main fuse
4. Main fuse
7-30
EAUM4760
12
1. Ignition fuse
2. Signaling system fuse
3. Headlight fuse
4. Fuel injection system fuse
5. Backup fuse (for clock and immobilizer sys-
tem)
6. Radiator fan motor fuse
7. ABS solenoid fuse
8. ABS motor fuse
9. Accessory fuse
10.Auxiliary fuse
4
3
11.ABS ECU fuse
12.Spare fuse
If a fuse is blown, replace it as follows.
1. Turn the key to "OFF" and turn off
the electrical circuit in question.
2. Remove the blown fuse, and then
install a new fuse of the speci ed
amperage. WARNING! Do not
use a fuse of a higher amperage
1
7
2
8
12
3
9
4
10
5
11
6
7
Advertisement
Table of Contents
Troubleshooting
