Shifting - Yamaha MT-10 2019 Owner's Manual

Operation and important riding points
1
NOTICE
If a warning or indicator light does
2
not come on initially when the key is
turned to "ON", or if a warning or in-
dicator light remains on, see page
3
4-5 for the corresponding warning
and indicator light circuit check.
4
The ABS warning light should
come on when the key is turned to
5
"ON", and then go off after travel-
ing at a speed of 10 km/h (6 mi/h)
6
or higher.
NOTICE
7
If the ABS warning light does not
come on and then go off as ex-
8
plained above, see page 4-5 for the
warning light circuit check.
9
2. Shift the transmission into the neu-
tral position. The neutral indicator
10
light should come on. If not, ask a
Yamaha dealer to check the elec-
11 trical circuit.
3. Start the engine by pushing the
" " side of the stop/run/start
12
switch.
If the engine fails to start, release
ECA11834 the stop/run/start switch, wait a
few seconds, and then try again.
Each starting attempt should be as
short as possible to preserve the
battery. Do not crank the engine
more than 10 seconds on any one
attempt.
NOTICE
For maximum engine life, never ac-
celerate hard when the engine is
cold!
ECA17682

Shifting

ECA11043
1. Shift pedal
2. Gear positions
Shifting gears lets you control the
amount of engine power available for
starting off, accelerating, climbing hills,
etc. The gear positions are shown in
the illustration.
TIP


6-2
6
5
4
2
1
3
2
N
1
To shift the transmission into the
neutral position ( ), press the
shift pedal down repeatedly until it
reaches the end of its travel, and
then slightly raise it.
This model is equipped with a
quick shift system. (See page 3-6.)
EAU77401