Yamaha MT-10 2019 Owner's Manual page 34

Instrument and control functions
starts flashing, the display automatical-
1
ly changes to the fuel reserve tripmeter
mode "TRIP F" and starts counting the
2
distance traveled from that point. In this
case, push the "SELECT" switch to
switch the display in the following order:
3
TRIP F  km/L or L/100 km  AVE
4
– –.– km/L or AVE – –.– L/100 km 
ODO  TRIP 1  TRIP 2  TRIP F
5
When set to miles:
TRIP F  MPG  AVE – –.– MPG 
6
ODO  TRIP 1  TRIP 2  TRIP F
7
TIP

To reset a tripmeter, select it by
8
pushing the "SELECT" switch, and
then push the "RESET" button for
9
two seconds.

If you do not reset the fuel reserve
tripmeter manually, it resets auto-
10
matically and disappears after re-
fueling and traveling 5 km (3 mi).
11
12
Instantaneous fuel consumption
mode
1
1. Instantaneous fuel consumption display
The instantaneous fuel consumption
display can be set to either "km/L",
"L/100 km" or "MPG" (when the
multi-function meter unit has been
set to miles).

"km/L": The distance that can be
traveled on 1.0 L of fuel under the
current riding conditions is shown.

"L/100 km": The amount of fuel
necessary to travel 100 km under
the current riding conditions is
shown.

"MPG": The distance that can be
traveled on 1.0 Imp.gal of fuel un-
der the current riding conditions is
4-13
shown.
To switch between the "km/L" and
"L/100 km", push the "CLOCK" and
"RESET" buttons at the same time.
TIP
If traveling at speeds under 20 km/h (12
mi/h), "– –.–" is displayed.
Average fuel consumption mode
1
1. Average fuel consumption display
This display shows the average fuel
consumption since it was last reset.
The average fuel consumption display
can be set to either "AVE – –.– km/L",
"AVE – –.– L/100 km" or "AVE – –.–
MPG" (when the multi-function meter
unit has been set to miles).