Yamaha MT-10 2019 Owner's Manual page 46

Instrument and control functions
Spring preload:
1
Minimum (soft):
Distance A = 77.5 mm (3.05 in)
2
Standard:
Distance A = 81.5 mm (3.21 in)
Maximum (hard):
3
Distance A = 85.5 mm (3.37 in)
3. Tighten the locknut to the specified
4
torque. NOTICE: Always tighten
the locknut against the adjust-
ing ring, and then tighten the
5
locknut to
torque.
6
[ECA22760]
Tightening torque:
7 Locknut:
25 N·m (2.5 kgf·m, 18 lb·ft)
8
Rebound damping force
To increase the rebound damping force
9
and thereby harden the rebound damp-
ing, turn the adjusting screw in direction
10 (a). To decrease the rebound damping
force and thereby soften the rebound
damping, turn the adjusting screw in di-
11
rection (b).
12
(a)
1. Rebound damping force adjusting screw
the specified
Rebound damping setting:
Minimum (soft):
Standard:
Maximum (hard):
* With the adjusting screw fully turned
in direction (a)
Compression damping force
Fast compression damping force
To increase the compression damping
force and thereby harden the fast com-
pression damping, turn the adjusting
bolt in direction (a). To decrease the
compression damping force and there-
1
(b)
23 click(s) in direction (b)*
11 click(s) in direction (b)*
1 click(s) in direction (b)*
4-25
by soften the compression damping,
turn the adjusting bolt in direction (b).
(a)
1. Fast compression damping force
adjusting bolt
Fast compression damping setting
Minimum (soft):
5.5 turn(s) in direction (b)*
Standard:
3 turn(s) in direction (b)*
Maximum (hard):
0 turn(s) in direction (b)*
* With the adjusting bolt fully turned in
direction (a)
Slow compression damping force
To increase the compression damping
force and thereby harden the slow
compression damping, turn the adjust-
ing screw in direction (a). To decrease
1
(b)