Graco PCF Instructions And Parts page 84

Appendix A - User Interface Display
Gateway Setup Screens
NOTE: The Gateway Setup screens are not available
if a Discrete Gateway Module is attached to the sys-
tem.
There are two Gateway Setup screens, which enable
users to set or change information regarding the Gate-
way module used on the PCF system. These screens
also enable users to view information regarding the par-
ticular Gateway module used.
Press to scroll through the Gateway Setup
screens. Once in the desired Advanced Setup screen,
press to access the fields to make changes. Press
to exit edit mode.
NOTE: Users must be out of edit mode to scroll
through the Gateway Setup screens.
Gateway Setup Screen 1 - DeviceNet
This screen enables users to set the device address and
the baud rate. The DeviceNet screen displays the hard-
ware revision number, system serial number, map ID,
name, revision number, and install date.
84
Gateway Setup Screen 1 - EtherNet/IP
This screen enables users to set the IP address, subnet
mask, Gateway, DNS 1, DNS 2, and if a DHCP is used.
Gateway Setup Screen 2 - EtherNet/IP
This screen is the same for EtherNet/IP and PROFIBUS.
It enables users to view the following information regard-
ing the Gateway module used on the PCF system:
• hardware revision number
• system serial number
• map ID number
• map name
• map revision number
• date the map was created
313377B