User Interface Display; Upgrade Gateway Module Software - Graco PCF Instructions And Parts

User Interface Display

Upgrade Software
NOTE: Back up the custom language file (if
installed) before upgrading software. See USB Data,
page 49, for more information.
1. Turn off power to the system.
2. Remove token access panel, and then remove the
key token (do not discard token).
Access Panel
F . 36: Remove Access Panel
IG
3. Insert and press token (CB) firmly into slot.
NOTE: There is no preferred orientation of token.
CB
F . 37: Insert Token
IG
4. Turn on power to the system. The red indicator light
(CA) will flash until new software is completely
loaded.
5. After the red indicator light shuts off, turn off power
to the system.
6. Remove token (CB).
7. Reinstall key token, and replace token access
panel.
Cleaning
Use any alcohol-based household cleaner, such as
glass cleaner, to clean the display.
313377B
Upgrade Gateway Module
Software
NOTE: The Gateway module connection to the sys-
tem is temporarily disabled during the installation of
upgrade tokens.
1. Turn off power to the system.
2. Remove the access cover (D).
DGM Shown
TI12365a
F . 38: Remove Access Cover
IG
3. Insert and press token (CB) firmly into slot.
NOTE: There is no preferred orientation of token.
4. Turn on power to the system. The red indicator light
CA
(CA) will flash until new software is completely
loaded.
DGM Shown
TI12366a
CA
CB
F . 39: Insert Token
IG
5. After the red indicator light shuts off, turn off power
to the system.
6. Remove token (CB).
7. Replace access cover.
Maintenance
Access
Cover
r_24B681_3B9904_3b
r_24B681_3B9904_4b
63