Roll-Over Protection Structure (Rops) - Wacker Neuson RD24 Instruction Manual

Tandem roller / combination roller
Hide thumbs Also See for RD24:
Table of Contents

Advertisement

Auxiliary equipment

Roll-over protection structure (ROPS)

6.00
Roll-over protection structure (ROPS)
194
The ROPS safety device (cab/roll-over bar) is a rollover protection
structure in the case the machine tilts or rolls over. It avoids that the
driver is crushed to death based on the high self-weight of the machine.
If the ROPS safety equipment is dismounted from the machine for
transport or repair, it must be remounted according to specifications
before the machine is used again.
High self-weight of machine!
If the machine overturns backwards, forwards or sideways there is a
danger of serious injuries or death.
Operate machine only with the ROPS safety device installed
according to instructions and while wearing the safety belt.
With detectable defects of the ROPS safety device or of its fixation
it is not allowed to operate the machine.
Installation
High self-weight of ROPS safety device!
Serious injuries or death caused by crushing or getting caught during
assembly.
Perform installation work on firm ground (flat, stable, horizontal).
Carry out fitting work only when the engine is stopped.
Use suitable load suspension and hitching gear with an adequate
loading capacity.
Do not step underneath suspended loads.
WARNING
WARNING
BA RD24_RD27 en 04

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rd27

Table of Contents