Baileigh Industrial SBR-5220 Operator's Manual page 32

6. While the sheet metal is being held firmly, both operators should rotate the handlebar to
make the bend to the desired angle.
7. Raise the brake blade die and remove the piece part.
Note: The brake die is designed to bend material up to 90°.
Adjust the fingers for box and pan bending:
1. Place a thin and flat piece of spacer material (A)
over the notch of the brake die. This flat surface
will help you obtain equal finger length.
2. With the handle assembly, lower the fingers so
they are just touching the top of the spacer on the
brake die.
3. Loosen, but do not remove, the six cap screws
(#20).
4. Slide the fingers horizontally to the desired position
or rearrange them to get the desired width
combination for your project.
5. Using the handle assembly, lower the fingers to
apply light pressure. Check to make sure each finger has continuous contact with the
spacer.
6. Tighten the six cap screws.
A
29
29
20