Configure Route Service; Upload Longitude And Latitude Info - HIKVISION DS-7600NI-K2/4G Series User Manual

5.5.5 Configure Route Service

The device can be used as a router to share its wireless network with other video recorder(s).
Before You Start
Ensure the wireless dial function is properly configured, and the wireless network is accessible.
●
Ensure other video recorder(s) are on the same network segment with your video recorder.
●
Steps
1. Go to Configuration → Wireless → Route Settings .
2. Turn on Enable Route Service.
3. Click Add.
4. Enter the IP address of the other video recorder.
5. Click OK.
6. Log in to the other video recorder, and set its gateway IP address. The gateway IP address is the
wired LAN IP address of your wireless network video recorder. You can go to Configuration →
Network → General → TCP/IP to view the IP address of your wireless network video recorder.
Note
You can repeat the above steps to add other video recorders.
7. Click Apply.

5.5.6 Upload Longitude and Latitude Info

After the GPS module (optional) is connected, the device can view longitude and latitude
information and upload it to platform.
Before You Start
The GPS module is optional, be sure the GPS module is properly connected to the ANT interface at
rear panel.
Steps
1. Go to Configuration → Wireless → Longitude and Latitude Info .
Network Video Recorder User Manual
Figure 5-22 Rout Settings
38