HIKVISION DS-7600NI-K2/4G Series User Manual page 69

Steps
1. Go to Configuration → Camera → Camera → IP Channel .
2. Click of an added network camera.
Channel Port
If the connected device is an encoding device with multiple channels, you can choose the
channel to connect by selecting the channel port No. in the drop-down list.
3. Click OK.
Upgrade Network Camera
The Network camera can be remotely upgraded through the device.
Before You Start
Ensure you have inserted the USB flash drive to the device, and it contains the network camera
●
upgrade firmware.
Ensure your network camera is on the same network segment with your video recorder.
●
Ensure the network connection is valid and correct.
●
Steps
1. Go to Configuration → Camera → Camera → IP Channel .
2. Click .
3. Click Yes to confirm.
4. Select the camera upgrade firmware from your storage device.
5. Click Upgrade to start upgrading. The camera will restarted automatically after upgrade
completed.
Configure Advanced Camera Parameters
You can configure advanced camera parameters like camera IP address, camera password, etc.
Before You Start
Ensure your network camera is on the same network segment with your video recorder.
●
Ensure the network connection is valid and correct.
●
Steps
1. Go to Configuration → Camera → Camera → IP Channel → IP Camera .
2. Click .
3. Set camera parameters like IP address, camera password, etc.
4. Click Apply.
Network Video Recorder User Manual
56