Preparations Before Installation; Terminal Introduction; Cable Specification - Goodwe MS Series User Manual

User Manual V1.0-2022-08-20

6.2 Preparations before Installation

6.2.1 Terminal Introduction

• The conduit needs to be provided by the user, and the specification of the conduit used
shall match the specification of the waterproof plug.
• It is recommended to use 1 inch cable gland for routing. The diameter for the routing hole
on the bottom of the inverter is 34mm (1.34 in).
• When installing the conduit, make sure the installation is in place and the hole between
the conduit and the inverter interface is sealed. Otherwise the protection level of the
equipment may be affected, which may cause damage to the equipment.
34mm(1.34in)
Diameter for the
inverter routing hole

6.2.1 Cable Specification

WARNING
19
06 Electrical Connection