Vesa-Mount Installation - Barco Coronis Uniti User Manual

Installation and setup
2. Fasten the foot on the desk with 4x M4 screws (length of the screws depending on the depth of the desk).

2.8 VESA-mount installation

CAUTION: Use suitable mounting apparatus to avoid risk of injury.
WARNING: Never move a display attached to an arm by pulling or pushing the display itself.
Instead, make sure that the arm is equipped with a VESA compliant handle and use this to move
the display.
Please refer to the instruction manual of the arm for more information and instructions.
WARNING: Use an arm that is approved by VESA (according to the VESA 200 x 100 mm or VESA
100 x 100 mm standard).
Use an arm that can support the weight of the display. Refer to the technical specifications of this
display for the applicable weight.
CAUTION: You should mount the panel in landscape position. Portrait position is possible but not
supported.
WARNING: To avoid muscle strain or back injury, use lifting aids and proper lifting techniques when
removing or replacing.
Overview
The panel, standard attached to the tilt & swivel foot, is compatible with the VESA 200 x 100 mm and VESA
100 x100 mm standard. So it can be used with an arm stand according to the VESA 200 x 100 mm or VESA
100 x 100 mm standard.
Therefore, the tilt & swivel foot must be removed from the panel.
1. Fasten the height mechanism of the foot by putting the red pin in the hole.
2. Put the display face down on a clean and soft surface. Be careful not to damage the panel screen.
3. Loosen the plastic covers with a cross head screwdriver.
4. Remove the two plastic covers.
18 K5902079 /11 Coronis Uniti